23' Mako Redesigned

• Page 1 Projects below the deck

• Page 2 Anchor locker and front compartment work

• Page 3 Transom removal and replacement

• Page 4 Forming the transom top cap

• Page 5 Replacing the front deck

• Page 6 Bottom/exterior hull work

• Page 7 Rolling the hull over and a new trailer

• Page 8 Beginning work on the cuddy cabin

• Page 9 Construction of the windshield and hard top

• Page 10 Installation of nav. lights and hard top work

• Page 11 Fabrication of the console/helm

• Page 12 Finishing the console/helm

• Page 13 Getting started again...

• Page 14 Building the port side console

• Page 15 Port side console con't

• Page 16 New motors on the way!

• Page 17 Glove box for port console

• Page 18 Fairing begins & collecting parts

• Page 19 Motor Bracket Mock-Up

• Page 20 Motors arrive & Motor mount jig

• Page 21 Filling holes in the console

• Page 22 Helm Mock-up & overhead electronics box

• Page 23 Overhead electronics box con't

• Page 24 More helm installation & Transducer

• Page 25 Prepping for paint

• Page 26 Windows & hardtop add-ons

• Page 27 Transducer installation

• Page 28 Topcoat goes on hullsides

• Page 29 Boot stripe

• Page 30 Rebuilding the bilge

• Page 31 Rebuilding the bilge con't

• Page 32 Finishing the bilge

• Page 33 Aft deck goes in & Scuppers

• Page 34 Transom cap filler panel & Wash down station

• Page 35 Wash down station installed

• Page 36 Pop-up cleats installed

• Page 37 Painting the top sides

• Page 38 Taping off the non skid

• Page 39 Non skid goes on

• Page 40 Finish work begins

• Page 41 Motor Bracket is painted

• Page 42 Bracket and motors installed

• Page 43 Crows nest fabricated and installed

• Page 44 Trim tabs, New trailer, & Float test